AutoLoader Operation Instruction
Overview
Welcome to use our products, we’ll sincerely serve you. For your better usage, please read the instructions carefully before starting the machine to avoid personal injury or damage to the machine.
Any question about the machine during your usage, please contact our local agent or headquarter company as below,
Zhongshan Lichen Plastics Technology Co., Ltd
Email: lceq@zslceq.com
Tel: +86 186 8018 7008
Operation Instruction
Under the “Shutdown” condition, press the “Set” button to enter the setting state, the display screen showing the current working mode. Press the “Up” or “Down” button to set the corresponding time to the current mode.
Press the “On/Off” button again to exit the Settings and return to the “Shutdown” condition.
Time Setting
C1 mode: Press “up” or “down” to modify the suction time value, “0~99S”.
C2 mode: Press “up” or “down” to modify the value of pause delay time, with the range of “10-99s”.
C3 mode: Press the “up” or “down” to modify the value of pause delay time, with the range of “1-99m”.
Note: If you do not press for 10S in the setting process, it will automatically exit the setting, saved the data, and return to the “Shutdown” condition.
The Function of Each Mode:
C1 mode: automatic material suction, delay 18S still lack material it will re-suck material, consecutive lacking material for 3 times, it will alarm.
C2 mode: automatic material suction, delay to set pause time value, if lacking material, it will alarm.
C3 mode: automatic material suction, delay to set pause time value if lacking material, it will alarm.
Operation Process
- Standby
After the autoloader is connected to a power source, the power lamp will be on, but the display screen not on. It is called a “Shutdown” state
.
- Power On
Under the Shutdown condition, press the On/Off button, and the system starts up.
If it is detected full material condition at this time, the RUN light flashes and the FULL light is on, the digital display showing the set loading time.
If the lack of material is detected, the system will suck material according to the set mode.
If there is a material shortage alarm, the system will stop working, the material shortage alarm flickers and the alarm relay will turn off.
- Shutdown
Under the power-on condition, press the On/Off button, and the system will return to the “Shutdown” state.
Maintenance:
A cloth filter is installed in the material storage hopper. Please open the material storage hopper and take out the filter to remove the dust attached to it, so as to maintain good ventilation and strong suction force. Please clean the cloth filter regularly.
Specification:
Model | VAL-300G | VAL-300E |
Motor type | Carbon brush type | Carbon brush type |
Motor power (kw) | 1.15 | 1.15 |
Feeding pipe (inch) | 1.5 | 1.5 |
Conveying capacity(kg/hr) | 300 | 300 |
Hopper capacity(L) | 6 | 6 |
Voltage | 1Φ,230VAC,50HZ | |
H | 550 | 730 |
W | 350 | 345 |
D | 350 | 325 |
Net weight (kg) | 13 | 14 |